Horner APG QX751 OCS - Manual (Page 31)

MAN0890-02-EN CH. 7
August 20, 2009 Page 31 of 96 ECN # 979
To select a different controller, click on the Device Type list box and scroll down to select the
desired controller. Then press OK. If satisfied with the controller now selected, press Base # tab
at the top of the screen. Then, go to Step 3.
Note: The Auto Config button can be pressed prior to selecting the desired controller. By
pressing the button, the settings are deleted from any controller that is physically connected to
the PC.
3.
The following screen appears. In this configuration example, I/O modules are going to be
selected and configured for Base 2.
Figure 7.3 – Main Base Screen appears with QX751 and BP43
Upon pressing the Base 2 tab, the following screen appears.
Figure 7.4 – Base 2 Selected
Any Base can be
selected. It is not
necessary to select
bases in a specific
order.
The Main base
contains the slots
directly located on the
back of the QX751.