AMETEK 1986XPJ Explosion Proof Resolver - Manual (Page 48)

48 1080 N. Crooks Road • Clawson, MI 48017 • 800.635.0289 • 248.435.0700 • Fax 248.435.8120 • www.ametekapt.com
AUTOMATION & PROCESS
TECHNOLOGIES
955
Input Voltage 13.5 to 30 VDC
Current Draw 2.5 Watts Maximum,
120 mA@15 VDC Typical
Output Analog: 0 to 10VDC, 10 to 0 VDC,
4 to 20 mA, 20 to 4mA.
Digital: Control Pulse, Variable
Pulse, Start/Stop
Quadrature: A+, A-, B+, B-, Z+ ,Z-
Line Drivers: 5V or Input Power
Resolution
Internal:
Analog Output:
Digital Output:
Quadrature:
Non-Linearity +/- 0.05% of Stroke
Repeatability +/- 0.006% of Full Stroke
Hysteresis +/- 0.02% of Full Scale
Update
Analog
50” or less:
51” to 100”:
101” to 150”:
151” to 180”:
Digital
Operating Temperature -20 to 70 C
Span Length 5” to 180”
Null Zone 3.00”
Dead Zone 2.00”
LED Tricolor diagnostic LED for communication of
LDT status.
Connector
955CA:
955CD:
955C DQ:
Approvals CE
Enclosure IP 67
IP 68 Optional
0.001”
16 Bit (1 part in 65,535)
Controller Dependent
0.001”
1ms
2ms
3ms
4ms
Controller Dependent
Specifications are subject to change without notice.
Specifications are based on a typical 36” LDT.
SPECIFICATIONS
o o
Standard 5 Pin Micro 12mm Euro Connector
Standard 6 Pin Micro 12mm Euro Connector
Standard 12 Pin Micro (option E)
12mm Euro Connector or 10 Pin HRS (option H)
LDT Specifications
It is recommended to use one mounting
bracket on each end and every 3 feet between.
It is recommended to use one pair of mounting
brackets on each end and every 3 feet between.
Side Mounting Foot
Part No. SD0559200
End Mounting Foot
Part No. SD0530600
Top Mounting Foot
Part No. SD0522000 Mounting Options for the 955C