Appendix “a” - application examples 71, Plastics extruder application 71 – Red Lion TCU User Manual
Page 79
APPENDIX “A” - Application Examples
Plastics Extruder Application
Several TCU controllers are employed to control the temperature of a
plastics extruder. Each TCU controls a heating element and a cooling water
solenoid to maintain each extruder zone at the desired temperature. The
heater current monitor of the TCU is used for early detection of heater
element failure. The linear DC output is used to retransmit the process
temperature to a control computer for data logging purposes.
71
Figure 41, Plastics Extruder Application
See also other documents in the category Red Lion Hardware:
- Data Station Plus (8 pages)
- Data Station Plus (8 pages)
- LDA (16 pages)
- LDSS (8 pages)
- LD (16 pages)
- LDT (16 pages)
- LPAX/MPAX (4 pages)
- EPAX/MPAX (8 pages)
- LDSG (20 pages)
- APS (2 pages)
- APS (2 pages)
- MLPS1 (2 pages)
- AFCM (2 pages)
- Converter Modules (4 pages)
- APMR (4 pages)
- RA 6000 Cellular RTU (2 pages)
- RA 9000 Cellular RTU (186 pages)
- IndustrialPr 6000 Router (2 pages)
- IndustrialPr 6000 Router (2 pages)
- RA 9000 Cellular RTU (3 pages)
- CSMSTRZR (8 pages)
- CSMSTR LE/SX/GT (8 pages)
- CSMSTRV2 (8 pages)
- CSOUT (4 pages)
- CSDIO (8 pages)
- CSTC8 (4 pages)
- CSINI8 (8 pages)
- CSPID (8 pages)
- CSSG (8 pages)
- DLC (28 pages)
- PAX2C (4 pages)
- PAX2C (56 pages)
- PXU (4 pages)
- PXU (32 pages)
- T16 (28 pages)
- TCU (10 pages)
- TSC (8 pages)
- TSC (92 pages)
- P48 (8 pages)
- PCU (8 pages)
- PCU (96 pages)
- PSC (8 pages)
- TLA (16 pages)
- ITMS (16 pages)