Red Lion TCU - Manual (Page 26)

Display Parameter
Range and
Units (Factory
Setting Value)
Description/
Comments
dt-2 Derivative
Time #2
(Secondary) 0 to 9999 sec.
(0) 0 is off. This parameter does not
appear if proportional band #2 =
0.0%. Second Analog Input
models only.
SP-2 Internal
Cascade
Directed
Setpoint -999 to 9999
(N/A) Second Analog Input models
only. Read only parameter.
rtio Remote
Setpoint ratio
multiplier 0.001 to 9.999
(1.000) Second Analog Input models.
bIAS Remote
Setpoint bias
offset 0 to 9999
(0) Second Analog Input models.
AL-1 Alarm 1
Value -999 to 9999, 1
or 0.1 degree
(0) Alarm option models only.
AL-2 Alarm 2
Value -999 to 9999, 1
or 0.1 degree
(0) This parameter does not appear if
the alarm option is not specified,
the cooling option is installed, or
if locked (LOC).
CNFP Configuration
Access
Point NO
1-IN
2-OP
3-LC
4-AL
5-02
6-SC
7-2N
8-VP
9-FS
Return to normal display mode.
Enter Configuration modules.
Configure input parameters.
Configure output parameters.
Configure parameter lockouts.
Configure alarm parameters (opt.)
Configure cooling output (opt.)
Configure serial communication
parameters (optional)
Configure second analog input
parameters (optional)
Configure valve positioner
parameters (optional)
Factory service operations
(Qualified technicians only)
End Unit returns
to Normal
Display Mode ____ Brief display message.
18