Red Lion GEMINI 33 - Manual (Page 41)

APPENDIX “D” - GEMINI 3300 BATCH COUNTER MODE FUNCTION COMMAND CODE SUMMARY
-39-
CODE MODE DESCRIPTION COMMENTS
52 OUTPUT 1 TERMINATION
- (+) Normal Phase Output normally “OFF”, turns “ON” at preset.
- (-) Reverse Phase* Output normally “ON”, turns “OFF” at preset.*
+/-1 Terminate at Output 2 Start
+/-2 Terminate at Output 2 End
+/-3 Terminate at Manual Reset
+/-4 Terminate at Manual Reset End
+/-5 Terminate at Output 1 Time Delay
53 NA TIMED OUTPUT 1 VALUE Range 0.01 to 599.99 sec.
54 OUTPUT 2 TERMINATION MODES
- (+) Normal Phase Output normally “OFF”, turns “ON” at preset.
- (-) Reverse Phase* Output normally “ON”, turns “OFF” at preset.*
+/-1 Terminate at Output 1 Start
+/-2 Terminate at Output 1 End
+/-3 Terminate at Manual Reset
+/-4 Terminate at Manual Reset End
+/-5 Terminate at Timed Output 2
55 TIMED OUTPUT 2 VALUE Range 0.01 to 599.99 sec.
61 RESET BUTTON & TERMINAL ACTUATION MODES
- (+) Maintained Unit remains reset at long as reset is activated
- (-) Momentary* Unit will reset instantly and will start counting again even if reset is
still activated
+/-1 Reset Process Counter
+/-2 Reset Batch Counter
+/-3 Reset Process and Batch Counter
+/-4 Reset Process, Batch and Total Counter
*Polarity sign is displayed in front of the identifier, a (-) sign is displayed, a (+) sign is not.