Red Lion GEMINI 33 - Manual (Page 28)

APPENDIX “A” - INSTALLATION & INPUT CONFIGURATION SWITCH SET-UP
Before installing the Gemini 3300 into the panel, the user should first
become familiar with the unit. It may also be desirable to program the unit and
appropriate DIP switches for the application at hand (Refer to the
“Programming and Applications” sections). Once the unit is programmed,
the settings will be saved in memory. The Program Disable “PGM. DIS.”
terminal should be connected to “COMM.” to prevent accidental or
unauthorized programming changes.
INSTALLATION ENVIRONMENT
The unit should be installed in a location that does not exceed the maximum
operating temperature and provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and neutral soap
product. Do NOT use solvents.
Continuous exposure to direct sunlight may accelerate the aging process of
the bezel.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to operate
the keypad of the unit.
The Gemini 3300 meets NEMA 4/IP65 requirements for indoor use,
when properly installed. The units are intended to be mounted into an
enclosed panel. Two mounting clips and screws are provided for easy
installation. Consideration should be given to the thickness of the panel. A
panel which is too thin may distort and not provide a water-tight seal.
(Recommended minimum panel thickness is 1/8".)
After the panel cut-out has been completed and deburred, remove the
backing from the adhesive side of the gasket, and carefully apply the
gasket to the panel. DO NOT APPLY THE ADHESIVE SIDE OF THE
GASKET TO THE COUNTER BEZEL. Insert the unit into the panel.
Install the screws into the narrow ends of the mounting clips as shown in
the drawing to the left. Thread the
screws into the clips until the pointed
end just protrudes through the other
side.
Install each of the two mounting
clips by inserting the wide lip of the
clips into the wide end of the holes
located on either side of the case.
Tighten the screws evenly, applying
uniform compression, thus providing a
water-tight seal.
Caution: Only minimum pressure is
required to seal panel. Do NOT over tighten mounting screws.
-26-
PANEL MOUNTING (Note, See Appendix “B” for Dimensions)