HP StorageWorks ESL9000 Tape Library - Manual (Page 94)

Maintenance and Troubleshooting
94 HP StorageWorks ESL9000 Series Tape Library User Guide
Operating Problems
Table 17 lists corrective actions for problems that might occur during library
operation. If the problem persists, contact your authorized service provider.
Table 17: Operating Problems
Problem Corrective Action
The host computer
cannot communicate
with the library, or one
or more of the drives.
■
Make sure that the library is on-line.
■
This might be a SCSI bus time-out or a premature
disconnect problem.
■
Check cable connections, cable length, SCSI
addresses, and termination.
■
If the library is communicating via Fibre Channel,
then check for:
— Addressing issues
— Mapping issues
— Zoning
— Fibre Channel cable damage
— Proper installation and configuration of HBAs
— Up-to-date firmware and drivers
■
Restart the host and the library.
A tape cartridge is
reported as not
present.
Note: This message indicates that the gripper could not
sense a tape cartridge in a particular storage bin, even
though the inventory reports that it is present.
■
Check to see if the designated cartridge is present. If it
is, make sure it is properly seated. (For a tape drive,
make sure the cartridge is completely unloaded.)
■
Retry the command.