HP StorageWorks ESL9000 Tape Library User Manual

Page 128

Sense Data Values

128

HP StorageWorks ESL9000 Series Tape Library User Guide

OVERLAPPED COMMANDS ATTEMPTED

Due to a second command being sent from the same host before a

previous command has completed, the previous command has been

aborted. This can also occur when executing off-line commands via the

control panel and DIAG port simultaneously.
Do not run backup software and diagnostic software at the same time.

MEDIUM REMOVAL PREVENTED

PREVENT MEDIUM REMOVAL

command was executed and command

was received to export cartridge. Attempt to move cartridge from

software. If unsuccessful, close software and try again from the GUI

control panel. If still unsuccessful, disconnect from host, power-cycle, and

retry the operation from the GUI control panel.

TRANSFER FULL - COMMAND CANNOT BE EXECUTED

Gripper has cartridge in it. Move cartridge to empty storage bin using

MOVE command. Retry command.

ELEMENT CONTENTS UNKNOWN

The contents of an element address are unknown. Issue an inventory

command.

ROTARY INVALID COMMAND

Rotary axis was commanded to a position out of its legal range. This is

an internal code failure.

EXTENSION INVALID COMMAND

Extension axis was commanded to a position out of the libraries

mechanical limits.
Upgrade firmware to latest revision.
Recalibrate the library.
If occurred when system was online, call your authorized service provider.

VERTICAL INVALID COMMAND

Vertical axis commanded to position out of library mechanical limits.
Calibrate the library.
Upgrade firmware to latest revision.
If occurred when system was online, call your authorized service provider.

Table 26: Sense Data Values (Hexadecimal) (Continued)

Sense

Key

ASC

ASCQ

Message Name/Description