HP StorageWorks ESL9000 Tape Library - Manual (Page 125)

Sense Data Values
125 HP StorageWorks ESL9000 Series Tape Library User Guide
04 8B 03
PASSTHRU MECHANICAL POSITION ERROR
Check for obstructions (cables, etc.).
Disconnect unit from power then manually move the axis to ensure it
moves freely between cabinets, with no binding or undue friction.
Retry command.
04 8B 08
PASSTHRU HOME NOT FOUND
Check for obstructions (cables, etc.).
Disconnect unit from power then manually move the axis to ensure it
moves freely between cabinets, with no binding or undue friction.
04 8B 20
PASSTHRU TEST FAILURE
Check for obstructions (cables, etc.).
Disconnect unit from power then manually move the axis to ensure it
moves freely between cabinets, with no binding or undue friction.
04 8B 22
PASSTHRU ENCODER FAILURE
The value of the pass-through encoder did not change during the self-test.
Check the motor encoder connection.
Check for obstructions (cables, etc.).
Disconnect unit from power then manually move the axis to ensure it
moves freely between cabinets, with no binding or undue friction.
04 8B 51
PTM ELECTRONICS NOT PRESENT
The library backplane needs to be upgraded. Call your authorized
service provider.
04 8C 06
LOAD PORT DOOR OPEN
Load port door unlocked but failed to open
04 8D 24
HANDLE HARDWARE
Stepper was unable to reach destination (open or close). Retry command.
If the failure recurs, run drive handle Self-test.
04 8E 01
FLASH MEMORY UNABLE TO IDENTIFY
Flash is soldered onto the board. Contact your HP service representative.
04 8E 02
FLASH MEMORY UNABLE TO ERASE
Flash is soldered onto the board. Contact your HP service representative.
04 8E 03
FLASH MEMORY UNABLE TO PROGRAM
Flash is soldered onto the board. Contact your HP service representative.
Table 26: Sense Data Values (Hexadecimal) (Continued)
Sense
Key ASC ASCQ Message Name/Description