HP StorageWorks ESL9000 Tape Library User Manual

Page 127

Sense Data Values

127

HP StorageWorks ESL9000 Series Tape Library User Guide

CLEANING CARTRIDGE INSTALLED

One of the following conditions exist:

■

A cleaning cartridge cannot be removed from a drive because it is

being used in a cleaning operation.

■

A cartridge cannot be placed into the drive because the drive is

being cleaned.

■

A cartridge cannot be placed into an empty storage element

because it is reserved for a cleaning cartridge that is currently in use

in a drive cleaning operation.

SAVING PARAMETERS NOT SUPPORTED

Make sure the backup software supports the library, and has the latest

patches.

MEDIUM NOT PRESENT

The inventory indicated that a cartridge was in this bin but no cartridge

was sensed by the gripper when it attempted to pick it.
Retry the command.
Check for proper seating of the cartridge.
If cartridge is truly not present, run inventory command.
It might also indicate that the tape is not ready to be picked from the drive

because the tape is not fully unloaded.
If the problem persists on an DLT drive, check the function of the tape

drive handle assembly. Manually unload the tape.

MEDIUM DESTINATION ELEMENT FULL

According to inventory, already contains a cartridge. If the destination is

truly empty, issue an inventory command and retry the

MOVE

command.

If the destination was full, retry the operation using an empty element as

the destination.

MEDIUM SOURCE ELEMENT EMPTY

According to inventory, source does not contain a cartridge. If the source

is truly full, issue an inventory command and retry the

MOVE

command. If

the source was truly empty, then retry the operation using a full element

as the source.

Table 26: Sense Data Values (Hexadecimal) (Continued)

Sense

Key

ASC

ASCQ

Message Name/Description