HP StorageWorks ESL9000 Tape Library User Manual

Page 134

Sense Data Values

134

PASSTHRU INVALID ACTUATOR START POSITION

Pass-through axis position is unknown. Issue a

CALIBRATE ALL

command.
Upgrade firmware to latest revision.
Call your authorized service provider.

PTM FULL

The PTM contains a cartridge. Issue a command to retrieve the cartridge

from the PTM and place it in either a bin or a tape drive.

8C 01

LOAD PORT TIMEOUT

The load port door was unlocked, but did not leave its current position

before time-out (30 seconds). This might be due to the door being stuck,

or in the case of a close operation, the operator not moving the door.

LOAD PACK DETENT FAILURE

The load pack bin detention spring is unable to hold or release the

cartridge. This is detected during a place if the tape does not stay seated

in the pack or during a pick if the tape does not eject from the pack.

DRIVE HANDLE TIMEOUT

Drive handle did not reach commanded position within time limits.
Retry the command.

LIBRARY UNIT COMMAND TIMED OUT

Verify that communications to the library still exists by issuing another

command. Check cabling.

Table 26: Sense Data Values (Hexadecimal) (Continued)

Sense

Key

ASC

ASCQ

Message Name/Description