HP StorageWorks ESL9000 Tape Library User Manual

Page 132

Sense Data Values

132

TRANSFER EMPTY - COMMAND ABORTED

Gripper does not contain cartridge at end of pick portion of

MOVE

command.
Check location of cartridge used in operation.
Retry operation.

COMMAND ABORTED BY USER

Informational message. No action is necessary.

CARTRIDGE IS ONLY PARTIALLY GRIPPED (ONLY SEEN IN
THE FRONT SENSOR)

Issue a

MOVE

command to move the cartridge from the transfer element

to an empty storage element.

LOAD RETRY FAILED

Library was unable to successfully load the drive, even after retries. Check

drive alignment. Reseat the drive. If the problem continues, drive might

need servicing.

GRIPPER TIMEOUT

Gripper did not reach desired position.

GRIPPER OPEN FAILURE

Gripper did not reach open position.
If this failure occurs after closing the door, or when the door is not

latched, then upgrade to the latest revision of firmware.

GRIPPER CLOSE FAILURE

Gripper did not reach close position.
If this failure occurs after closing the door, or when the door is not

latched, then upgrade firmware to latest revision.

UNABLE TO PICK CARTRIDGE

Cartridge was sensed in front gripper sensor, but was unable to seat

cartridge in the rear gripper sensor. Check that gripper sensors are

working and/or that tape was ejected far enough.

ROTARY FRONT FAILED

The rotary move to the front position failed.
Retry the command.

Table 26: Sense Data Values (Hexadecimal) (Continued)

Sense

Key

ASC

ASCQ

Message Name/Description