HP StorageWorks 1510i Modular Smart Array - Manual (Page 19)

2 Initial configuration sequence
The MSA can be completely configured using the CLI. If you want to use the HP Storage Management
Unit (SMU), but the factory default management network settings do not work in your environment, see
Configuring static management settings .
The example commands shown in this chapter are provided as a general reference and may differ from
the commands needed for your configuration. The examples show the command that is typed in at the
CLI prompt and the system response. For more information on the available options for each command,
see Command reference in this guide or the CLI online help.
When configuring the MSA for the first time, use the following sequence:
• Configure logical drives
• Configure a basic iSCSI setup
• Configue CHAP authentication for iSCSI connection for iSCSI connections
• Configure Access Controls for LUN access
• Enable iSNS discovery of the iSCSI target
• Enable SLP discovery of the iSCSI target
• Configuring static management settings
Configure logical drives
Before creating any logical drives, ensure that all disk enclosures are physically connected to the MSA,
so that the disks are available for configuration.
1. [Optional] Verify that the disks are detected by the array controller using the show disks command:
CLI> show disks
Disk List: (box,bay) (B:T:L) Size Speed Units
Enclosure 1: SATA (0:03:00) PROLIANT 8LCE 1.16
Disk101 (1,01) (0:03:01) 250.0GB 160 MB/s none
Disk102 (1,02) (0:03:02) 250.0GB 160 MB/s none
Disk103 (1,03) (0:03:03) 250.0GB 160 MB/s none
Disk104 (1,04) (0:03:04) 250.0GB 160 MB/s none
Disk105 (1,05) (0:03:05) 250.0GB 160 MB/s none
Enclosure 2: SCSI (1:06:00) PROLIANT 4LEE JB4F
Disk207 (2,07) (1:08:00) 72.8GB 160 MB/s none
Disk208 (2,08) (1:09:00) 72.8GB 160 MB/s none
Disk209 (2,09) (1:10:00) 72.8GB 160 MB/s none
Disk210 (2,10) (1:11:00) 36.4GB 160 MB/s none
1510i Modular Smart Array Command Line Interface user guide 19