HP Color LaserJet Enterprise CM4540 MFP series - Manual (Page 100)

Manually configure IPv6 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv6 address.
1. From the Home screen, scroll to and touch the Administration button.
2. To enable manual configuration, open each of the following menus:
a. Network Settings
b. Embedded Jetdirect Menu
c. TCP/IP
d. IPV6 Settings
e. Address
f. Manual Settings
g. Enable
Select the On option, and then touch the Save button.
3. To configure the address, open each of the following menus:
● Network Settings
● Embedded Jetdirect Menu
● TCP/IP
● IPV6 Settings
● Address
Use the keypad to enter the address.
NOTE: If you are using the arrow buttons, you must press the OK button after entering each
digit.
80 Chapter 5 Connect the product ENWW