HP Identity Driven Manager Software Series - Manual (Page 92)

3-28
Using Identity Driven Manager
Configuring Network Resources
Figure 3-22. Define Network Resource
2. Define the properties for the network resource.
Table 3-4. IDM Network Resource parameters
Field/Section Entry
Name The name used to identify the network resource
Description A brief description of the network resource (optional)
Resource Attributes:
IP Address/IPv6
Address
To filter by device address, clear the Any Address check box, select the
address type as either IP Address or IPv6 Address, and type the IP address
for the switch associated with the resource in the IP Address field.
Use the Any address option if you will be filtering by Protocol and
application port only, and not by specific device or port.
Mask The subnet mask for the IP Address (if used). Use the up/down buttons [ ▲,
▼ ] to set the mask number.
Protocol Select UDP, TCP, or IP to identify the protocol used to filter access to the
resource. Protocol can be used alone or with an IP address and port
parameters to define the network resource access.
To use a custom protocol number for a network resource, check the Enter
protocol number check box and type the protocol number (0-137)