HP Designjet T7100 Printer series - Manual (Page 43)

4. Wind any trailing paper manually onto the roll.
5. Move the left hub to the left by pressing the blue lever.
6. Remove the roll.
7. Close the roll door.
View information about the paper
On the printer's front panel, select the icon, and then select View paper source.
The following information appears on the front panel:
● The roll status
● The paper type that you have selected
● The width of the paper in millimeters (estimated by the printer)
● The length of the paper in millimeters (estimated by the printer)
● The color calibration status
● The paper advance calibration status
If no paper is loaded, the message Out of paper appears.
The same information appears on the Embedded Web Server's Supplies page.
Perform paper advance calibration
The printer is calibrated to advance correctly when printing all the papers that appear on the front
panel. When you select the type of loaded paper, the printer adjusts the rate at which it advances the
paper while printing. However, to fine-tune the image quality of your print, you may need to calibrate
the rate at which the paper advances. See Troubleshoot print-quality issues on page 147 to determine
whether paper-advance calibration is the solution for your issue.
Accurate paper advance controls proper placement of dots on the paper. If the paper is not advanced
correctly, light or dark bands appear in the printed image and the grain in the image might increase.
The printer starts paper advance calibration automatically if accurate paper advance is particularly
important for the loaded paper type. This can happen after the paper is loaded or after printhead
replacement.
ENWW View information about the paper 35
Handle the paper