HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 75)

Command line 75
Item Description
Parameter
PortID (required) The ID of the port to modify. The specified port must already be added to a network or
uplink port set. The port ID is in the format
::
Properties
Network
(required)
The name of the network to which the port belongs if the uplink set name is not
specified.
UplinkSet
(required)
The name of the shared uplink port set to which the port belongs if the network name is
not specified.
Speed (optional) Specifies the port speed for the port. Acceptable values include "Auto", "10Mb",
"100Mb", "1Gb", "10Gb", and "Disabled".
If there is no connector present on the uplink port, only "Auto" and "Disabled" can be
configured as possible speeds. Speed restrictions apply.
Role (optional) The role played by the port if the connection mode of the network or shared uplink set
is selected as "Failover". The default value is "Primary".
Examples
->set uplinkport enc0:1:2 Network=MyNetwork Speed=1Gb
Changes the port speed of a network port
->set uplinkport enc0:2:1 Network=MyNetwork Speed=Disabled
Disables a specific port that belongs to a network
->set uplinkport enc0:2:4 UplinkSet=MyUplinkSet Speed=Disabled
Disables a specific port that belongs to a shared uplink set
->set uplinkport enc0:2:4 Network=MyNetwork Role=Secondary
Modifies the role of the network uplink port with the connection mode on the network or
the shared uplink set as "Failover" to take the primary port role
Item Description
show uplinkport Display all Ethernet module uplink ports known to the domain. If the port is a member
of a network or a shared uplink port set, then it appears also.
Syntax
show uplinkport [FilterBy]
Parameters
PortID (optional) The ID of an uplink port. The PortID format is
::. "*" displays a detailed view of all uplink
ports.
FilterBy
(optional)
Filters the output of the show command by the specified attribute. The option is
specified in the format =. For example, to display uplink ports
belonging to enclosure enc0, the option would be specified as ID=enc0. To display all
the ports using connector type RJ-45, the option would be Type=RJ45. You can
specify more than one filter option for a single command; for example, show
uplinkport ID=enc0 Type=RJ45.
Examples
->show uplinkport
Displays all uplink ports
->show uplinkport enc0:5:6
Displays details of uplink port 6 in bay 5 of the local enclosure
->show uplinkport *
Displays all uplink ports in the enclosure (detailed view)
->show uplinkport ID=enc0:1
Displays all the uplink ports for the specific bay (for example, for bay 1)