HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 126)

Configuring the Virtual Connect domain using the CLI 126
Virtual Connect Manager not found at this IP address.
If the user attempts to log in to the secondary I/O bay, they might receive the following error message during
the attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry again
later.
The login should succeed after the Virtual Connect Manager has restarted on this secondary Virtual Connect
Ethernet module. Allow up to 5 minutes, depending on the enclosure configuration.
If the command line option -failover is not included in the reset vcm command or a Virtual Connect
Ethernet module is not available in the alternate I/O bay, the command line displays the following message:
SUCCESS: The Virtual Connect Manager is being reset. Please wait...
The user is logged out of the session after approximately 1 minute. If the user attempts to re-login, they might
receive the following error message during the attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry again
later.
The login should succeed after the Virtual Connect Manager has restarted. Allow up to 5 minutes, depending
on the enclosure configuration.