HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 40)

Command line 40
Item Description
MutualUsername
(required if
authentication type is
CHAPM)
The mutual user name for CHAPM authentication. The user name length is a
maximum of 223 characters. If the name contains non-alphanumeric
characters, it must be enclosed in double quotation marks.
MutualSecret (required
if authentication type
is CHAPM)
The mutual secret password for CHAPM authentication. The password should
be specified as a string or a long hex value (starting with '0x'). This value must
be at least 96 bits (12 bytes, 24 hex digits) and at most 16 bytes, 32 hex digits
long. The mutual secret can be entered as clear text in the command or as a
masked string at the prompt.
ISCSIBootParamDHCP
(optional)
Enables the iSCSI option ROM to retrieve the iSCSI boot parameters from DHCP
or through static configuration. Valid values are "Enabled' and "Disabled". The
default selection for this attribute is "Disabled", which enables static
configuration.
NetworkParamDHCP
(optional)
Enables the iSCSI option ROM to retrieve the TCP/IP parameters from DHCP or
through static configuration. Valid values are "Enabled" and "Disabled'. The
default selection for this attribute is "Disabled", which enables static
configuration.
DHCPVendorID (required
if ISCSIBootParamDHCP
is "Enabled")
This string is used to match the value in the Vendor Class ID field in the DHCP
offer packet when retrieving iSCSI boot parameters.
Examples
->set iscsi-boot-param MyProfile1:1 BootOrder=Primary
Lun=100
InitiatorName="iqn.2009-09.com.someorg.iSCSI-Initiator"
InitiatorIp=192.128.3.1 Mask=255.255.0.0
TargetName="iqn.2009-09.com.someorg.iSCSI-Target"
TargetIp=192.128.3.2 TargetPort=40000 Authentication=CHAP
Username=SomeUserName Secret=SomePassword123
Configures basic boot attributes on an iSCSI connection of profile MyProfile1
->set iscsi-boot-param MyProfile1:1 BootOrder=Primary
ISCSIBootParamDHCP=Enabled NetworkParamDHCP=Enabled
DHCPVendorID=SomeVendorIDValue
Configures iSCSI Boot attributes to be retrieved from DHCP
->set iscsi-boot-param MyProfile1:1 -maskSecret
-maskMutualSecret Authentication=CHAPM
Username=SomeUserName MutualUsername=SomeMutualUsername
ISCSIBootParamDHCP=Enabled NetworkParamDHCP=Enabled
DHCPVendorID=SomeVendorIDValue
Configures CHAP secret and CHAPM secret values as a masked string
Item Description
show iscsi-boot-param Display the basic iSCSI boot parameters configured on the specified iSCSI
connection.
Syntax
show iscsi-boot-param []
Parameter
ConnectionID
(optional)
The ID of an existing iSCSI connection. The ID format is .
The show profile command can be used to display the
port number of the iSCSI connection.