HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 54)

Command line 54
Item Description
add port monitor Add a new network analyzer port and other ports to be monitored.
Syntax
add port-monitor [AnalyzerPort=]
[Speed=]
[Duplex=] [MonitorPort=]
[Direction=]
Properties
AnalyzerPort
(optional)
The uplink port that is used for monitoring network traffic. Only one port can be
configured as the analyzer port.
After a port has been allocated to port monitoring, it is not available for use in VC
networks and shared uplink sets.
The format of the network analyzer port is
::.
If the enclosure ID is not specified, the default enclosure is the local enclosure where
the domain resides.
Speed (optional) The port speed for the network analyzer port. Valid values include "Auto",
"10Mb", "100Mb", "1Gb", "10Gb", and "Disabled". The default value is "Auto".
If there is no connector present on the analyzer port, only "Auto" and "Disabled"
can be configured as a possible speed. Speed restrictions apply.
Duplex (optional) The duplex mode of the network analyzer port. Valid values include "Auto", "Half",
and "Full". The default value is "Auto".
MonitorPort
(optional)
The server port to be monitored. The format of the monitored port is
::. If the enclosure ID is not
specified, the default enclosure is the local enclosure.
The ID for the monitor port can be referenced from the ID column in the output of the
show server-port command.
Direction (optional) The direction of network traffic on the port being monitored. Valid values include
"ToServer", "FromServer", and "Both".
Example
->add port-monitor AnalyzerPort=enc0:1:4 Speed=1Gb
Duplex=full MonitorPort=enc0:5:4 Direction=FromServer
Adds a new network analyzer port and a server port to be monitored
Item Description
remove port-monitor Remove ports from a port monitor configuration. Removing the network analyzer
port causes port monitoring to be disabled automatically.
Syntax
remove port-monitor AnalyzerPort=
MonitorPort=
Properties
AnalyzerPort The network analyzer port to be removed. "*" removes all the network analyzer
ports from the configuration.
MonitorPort The monitor port to be removed. "*" removes all the monitor ports from the port
monitor configuration.
Examples
->remove port-monitor AnalyzerPort=enc0:3:1
Removes the network analyzer from the configuration
->remove port-monitor AnalyzerPort=*