HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 39)

Command line 39
Item Description
Properties
BootOrder (optional) Enables or disables iSCSI boot. To enable iSCSI boot, select Primary,
Secondary, or USE-BIOS. The default selection for this attribute is Disabled.
LUN (optional) The LUN of the Target identifies the volume to be accessed. Valid values for
standard LUNs are 0 to 255 decimal. Valid values for extended LUNs are 13- to
16-character hexidecimal values. The default is 0.
InitiatorName
(required if
ISCSIBootParamDHCP is
"Disabled")
The name used for the iSCSI initiator on the booting system. The initiator name
length can be a maximum of 223 characters. If the initiator name string contains
non-alphanumeric characters, it must be enclosed in double quotation marks.
InitiatorIP (required
if Network ParamDHCP is
"Disabled")
The IP address used by the iSCSI initiator. This value is in dotted decimal format.
Mask (required if
NetworkParamDHCP is
"Disabled")
The IP network mask used by the iSCSI initiator. This value is in dotted decimal
format.
Gateway (optional) The default IP route used by the iSCSI initiator. This value is in dotted decimal
format.
VlanID (optional) The VLAN number that the iSCSI initiator uses for all sent and received packets.
Valid values range from 1 to 4094.
TargetName (required if
ISCSIBootParamDHCP is
"Disabled")
The name of the target from which to boot. The target name length is a maximum
of 223 characters. If the name string contains non-alphanumeric characters, it
must be enclosed in double quotation marks.
TargetIP (required if
ISCSIBootParamDHCP is
"Disabled")
The primary IP address of the iSCSI target
TargetPort (optional) The TCP port associated with the primary target IP address. The default value is
3260.
TargetIP2 (optional) The alternate target IP address to use if the primary port is unavailable
TargetPort2 (required
if TargetIP2 is
specified)
The TCP port associated with the alternate target IP address. The default value is
3260.
Authentication
(optional)
The initiator and target must agree on an authentication method, or the iSCSI
initiator cannot log in to the target. Supported Authentication values include
"None", "CHAP", and "CHAPM". The default selection for this attribute is
"None".
Username (required if
authentication type is
CHAP or CHAPM)
The user name for authentication. The user name length is a maximum of 223
characters. If the name contains non-alphanumeric characters, it must be
enclosed in double quotation marks.
Secret (required if
authentication type is
CHAP or CHAPM)
The secret password for CHAP and CHAPM authentication. It is specified as a
string or a long hex value (starting with '0x'). This value must be at least 96 bits
(12 bytes, 24 hex digits) and at most 16 bytes, 32 hex digits long. The CHAP
secret can be entered as clear text in the command or as a masked string at the
prompt.