HP LaserJet 3055 - Manual (Page 93)

Canceling a fax job
Use these instructions to cancel a single fax that is currently dialing or a fax that is being transmitted
or received.
To cancel the current fax job
Press Cancel on the control panel. Any pages that have not been transmitted are canceled. Pressing
Cancel also stops group-dial jobs.
To cancel a fax job by using the Fax Job Status
Use this procedure to cancel a fax job in the following situations:
● The all-in-one is waiting to redial after encountering a busy signal, an unanswered call, or a
communication error.
● The fax is scheduled to be sent at a future time.
Use the following steps to cancel a fax job by using the Fax Job Status:
1. On the all-in-one control panel, press Menu .
2. Press to select Fax Job status.
3. Use the < or the > button to scroll through pending jobs until you reach the job that you want to
clear.
4. Press to select the job that you want to cancel.
5. Press to confirm that you want to cancel the job.
Changing the default light/dark (contrast) setting
The contrast affects the lightness and darkness of an outgoing fax as it is being sent.
To change the default light/dark (contrast) setting
The default light/dark setting is the contrast that is normally applied to items that are being faxed.
The slider is set to the middle as the default setting.
1. On the all-in-one control panel, press Menu .
2. Use the < or the > button to select Fax setup, and then press .
3. Use the < or the > button to select Fax Send setup, and then press .
4. Use the < or the > button to select Def. Light/dark, and then press .
5. Use the < button to move the slider to the left to make the fax lighter than the original, or use the
> button to move the slider to the right to make the fax darker than the original.
6. Press to save your selection.
ENWW Basic fax features and tasks 75