HP LaserJet 3055 - Manual (Page 172)

Set up the all-in-one and use it on the network
(HP LaserJet 3052/3055/3390/3392 all-in-one only)
Hewlett-Packard recommends that you use the HP software installer on the CDs that came with the
all-in-one to set up printer drivers for the following network setups.
NOTE Networking capabilities are not available for the HP LaserJet 3050 all-in-one.
HP LaserJet 3052/3055 HP LaserJet 3390/3392
Figure 9-1 Network port location
Configuring a network-port-connected all-in-one
To configure a network-port-connected all-in-one configuration (direct mode or peer-to-peer
printing)
In this configuration, the all-in-one is connected directly to the network, and all computers on the
network print directly to the all-in-one.
NOTE This mode is the recommended network configuration for the all-in-one.
1. Connect the all-in-one directly to the network by inserting a network cable into the all-in-one
network port.
2. Use the all-in-one control panel to print a Configuration page.
3. Insert the all-in-one CD into your computer. If you have already set up your all-in-one, click
Install Software to start the software installer. If the software installer does not start, navigate to
the hpsetup.exe file on the CD and double-click the file.
4. Click Install HP LaserJet 3052/3055/3390/3392 all-in-one Software.
5. On the Welcome screen, click Next.
6. On the Installer updates screen, click Yes to search for installer updates on the Web.
7. For Windows 2000/XP, on the Installation Options screen, choose the installation option.
Hewlett-Packard recommends a typical installation, if your system supports it.
8. On the License Agreement screen, read the license agreement, indicate that you accept the
terms, and then click Next.
9. For Windows 2000/XP, on the HP Extended Capabilities screen, choose whether you want
extended capabilities, and then click Next.
154 Chapter 9 Networking ENWW