Set my network password – HP LaserJet 3055 User Manual
Page 257
To change from a direct-connected shared all-in-one to a network port-
connected all-in-one configuration
To change from a direct connection to a network configuration, complete the following steps.
1.
Uninstall the printer driver for the direct connect all-in-one.
2.
Install the driver as a network configuration by using the steps in
connected all-in-one configuration (direct mode or peer-to-peer printing)
Set my network password
Use HP ToolboxFX to set a network password.
1.
Open HP ToolboxFX and click Device Settings.
2.
Click the Network Settings tab.
NOTE
If a password has been set for the all-in-one previously, you will be prompted to
type the password. Type the password, and then click Apply.
3.
Click Password.
4.
In the Password box, type the password you want to set, and then in the Confirm password
box, type the same password again to confirm your choice.
5.
Click Apply to save the password.
ENWW
Network: How do I?
239