HP LaserJet 3055 - Manual (Page 185)

NOTE The MAC address for your all-in-one is available on the network
configuration page.
d. Under Supported types, select DHCP only, then click Add.
NOTE Selecting Both or BOOTP only will result in a configuration through BOOTP
due to the sequence in which the all-in-one initiates configuration protocol requests.
e. Specify another reserved client, or click Close. The reserved clients added will be
displayed in the Reservations folder for this scope.
12. Close the DHCP manager utility.
NetWare systems
NetWare 5.x servers provide DHCP configuration services for network clients, including your HP all-
in-one. To set up DHCP services on a NetWare server, refer to Novell documentation and support.
To discontinue DHCP configuration
CAUTION Changes to an IP address on your all-in-one may require updates to all-in-one or
system printing configurations for clients or servers. If you do not want your all-in-one
configured through DHCP, you must reconfigure the all-in-one with a different configuration
method. You can manually modify the TCP/IP parameters through a supported Web browser
using the embedded Web server, the control panel, or HP ToolboxFX. If you change to
BOOTP configuration, the DHCP-configured parameters are released and the TCP/IP protocol
is initialized. If you change to Manual configuration, the DHCP-configured IP address is
released and the user-specified IP parameters are used. Therefore, if you manually provide
the IP address, you should also manually set all of the configuration parameters, such
as subnet mask and default gateway.
ENWW Using DHCP 167