HP LaserJet 3055 - Manual (Page 223)

Transparencies and labels
Only use transparencies and labels that are recommended for use in laser printers, such as
HP transparency film and HP LaserJet labels. See
Guidelines for using media for more information.
CAUTION Be sure to set the correct media type in the all-in-one settings. The all-in-one
adjusts the fuser temperature according to the media type setting. When printing on special
media such as transparencies or labels, this adjustment prevents the fuser from damaging the
media as it passes through the all-in-one.
CAUTION Inspect the media to make sure that it is not wrinkled or curled and that it does
not have any torn edges or missing labels.
NOTE You can load multiple transparencies in the main input tray (tray 2). However, do not
load more than 75 transparencies at a time.
Custom-size media and card stock
Use the main input tray for multiple sheets. See Supported media weights and sizes for the
supported media sizes.
CAUTION Make sure that the sheets are not stuck together before you load them.
Colored paper
● Colored paper should be of the same high quality as white xerographic paper.
● Pigments used must be able to withstand the fuser temperature of 200°C (392°F) for 0.1 second
without deterioration.
● Do not use paper with a colored coating that was added after the paper was produced.
Envelopes
Only use envelopes that are recommended for laser printers. See Guidelines for using media for
more information.
NOTE For the HP LaserJet 3390/3392 all-in-one, you must load envelopes one at a time in
the single-sheet priority input slot (tray 1).
To prevent the envelope from curling as it prints, open the rear output door (HP LaserJet 3390/3392
all-in-one).
ENWW Print: How do I? 205