HP LaserJet 3055 - Manual (Page 300)

Macintosh Configure Device (Mac OS X V10.3 and Mac
OS X V10.4)
Macintosh Configure Device is a Web-based program that provides access to information about the
all-in-one (for example, information about supplies status and all-in-one settings). Use Macintosh
Configure Device to monitor and manage the all-in-one from the computer
NOTE You must perform a complete software installation to use Macintosh Configure Device.
● Check the all-in-one status and print information pages.
● Check and change all-in-one system settings.
● Check default print settings.
● Check and change fax settings, including fax send, fax receive, fax phone book and speed-dial
settings, and fax reports.
● Check and change network settings, including IP configuration, Advanced, mDNS, SNMP,
network configuration, and password.
You can view Macintosh Configure Device when the all-in-one is directly connected to your computer
or when it is connected to the network.
NOTE You do not have to have Internet access to open and use Macintosh Configure Device.
To view Macintosh Configure Device when the all-in-one is directly connected to the computer
1. Open HP Director by clicking the HP Director icon in the dock.
2. In HP Director, click Settings.
3. Select Configure device to open the Macintosh Configure Device home page in a browser.
To view Macintosh Configure Device when the all-in-one is connected to a network
1. Open one of the following supported Web browsers:
● Safari 1.2 or later
● Microsoft Internet Explorer 5.0 or later
● Netscape Navigator 4.75 or later
● Opera 6.05 or later
2. Enter the IP address of the all-in-one into the Web browser to open the Macintosh Configure
Device home page.
282 Chapter 12 Managing the all-in-one and maintenance ENWW