HP ProLiant DL180 Server - Manual (Page 8)

Installation of the HP Lights-Out 100c Remote Management Card 8
Installation of the HP Lights-Out 100c Remote
Management Card
Remote management card kit contents
For HP ProLiant ML110 G5, ML115 G5, DL120 G5, ML150 G5, and DL180 G5 servers, you must install
the HP Lights-Out 100c Remote Management Card to activate the LO100 optional features. For more
information, see "LO100 optional features (on page
6 )."
The HP ProLiant Lights-Out 100c Remote Management Card Kit includes the following components:
• HP Lights-Out 100c Remote Management Card
• Spacer support
• Remote management card installation instructions
Preinstallation procedures
The installation procedures in this document are intended for individuals who are qualified in the servicing
of computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING: Failure to properly turn off the server before you open the server may cause
serious damage to the equipment as well as bodily harm.
CAUTION: Follow the ESD precautions listed in your server guide when handling the remote
management card.
IMPORTANT: Observe the pre- and post-configuration procedures described in later sections
when installing the remote management card.
NOTE: The procedures described in this section assume that the server is positioned on a flat,
stable surface.
1. Back up the server data.
2. Shut down the operating system as outlined in the operation system instructions.
3. Power off the server and all the connected peripherals.
4. Unplug all power cords.
CAUTION: Failure to properly remove the power cord from the server before adding or
removing a LO100 card might cause serious damage to the equipment.
5. Label each cable, if not already labeled, to expedite reassembly.
6. Disconnect telecommunication cables to avoid exposure to shock hazard from ringing voltages.
7. Open the server according to the instructions described in your server manual.