Enabling telnet and http services – HP ProLiant DL180 Server User Manual
Page 15
Configuration 15
ii.
On DHCP IP Source, select Disabled.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On ML115 G5 servers:
i.
Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press the Enter
key.
ii.
Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
iii.
On DHCP IP Source, select Disabled.
iv.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On DL120 G5 servers:
i.
Press the down arrow (↓) key to scroll to the LAN Settings menu. Press the Enter key.
ii.
On IP Address Assignment, select Static.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On DL160 G5, DL165 G5, DL180 G5, and DL185 G5 servers:
i.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter key.
ii.
On DHCP IP Source, select Disabled.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab or period (.) key to move between address fields).
o
On SL165z G6 servers:
i.
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
ii.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter key.
iii.
Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
iv.
Select either of the following:
—
To set BMC NIC to Disabled, press the Enter key.
—
To save all changes and exit, press the F10 key.
5.
Press the F10 key to save and exit.
To restore DHCP, see "Configuring network settings using the BIOS Setup Utility (on page
)."
Enabling telnet and HTTP services
On DL160 G5, DL165 G5, DL185 G5, and SL165z G6 servers, HTTP and telnet are enabled by default.
On ML110 G5 and ML115 G5 servers:
1.
Select Advanced>IPMI>LAN Configuration.
2.
Set the following:
o
BMC HTTP Service—Enabled
o
BMC Telnet Service—Enabled
On the DL120 G5:
1.
Select Advanced>IPMI>LAN Settings.
- ProLiant DL180 G5 Server ProLiant ML150 G5 Server ProLiant ML110 G5 Server ProLiant DL160 G5p Server ProLiant DL120 G5 Server ProLiant ML115 G5 Server ProLiant DL165 G5 Server ProLiant DL160 G5 Server ProLiant DL165 G5p Server Lights-Out 100 Remote Management ProLiant SL165z G6 Server ProLiant DL185 G5 Server