HP ProLiant DL180 Server - Manual (Page 46)

Using LO100 46
Remote Access Configuration
— Remote Access—Enabled
— EMS support(SPCR)—Enabled
o On HP ProLiant DL180 G5 and SL165z G6 servers, verify the following settings:
Remote Access Configuration
— Remote Access—Enabled
— EMS support(SPCR)—Enabled
— Terminal Type—VT100
— Flow Control—None
— Redirection after BIOS POST—Always
SuperIO Configuration
— Serial Port Address—3F8
— Serial Port IRQ—IRQ 4
2. In the /boot/grub/menu.lst file, append the following to the kernel startup line:
console=ttyS0 115200
Comment out the line GRAPHICAL DISPLAY LINE
# splashimage=(hd0,0)/grub/splash.xpm.gz
3. Add an entry to allow serial console login in /etc/inittab. For example:
S0:12345:respawn:/sbin/agetty -L 115200 ttyS0 vt102
4. In /etc/securetty enable root access to ttyS0 by adding ttyS0.
5. In /etc/sysconfig/kudzu, set kudzu to not perform serial port probing during boot. For example:
SAFE=yes
6. After modifying and saving the previous files, reboot the server. You can now log in to the operating
system through remote console.
After POST, in the remote console, the server prompts you with a login. Enter a valid login and use the
server as you normally would. Use the ESC+Q keys to start remote console through the telnet and the
ESC+( keys to exit the remote console in telnet.
Microsoft Windows EMS management
Microsoft® Windows Server® 2003 provides text-based console access. You can connect a notebook to
LO100 to perform basic management tasks on the target system. The Windows® EMS Console, if
enabled, displays the processes that are running and enables administrators to halt processes. This
capability is important when video, device drivers, or other operating system features have prevented
normal operation and normal corrective actions.
To enable Windows® EMS management on the target system:
1. Press the F10 key during POST to enter the BIOS Setup Utility.
2. Navigate to the Advanced>Console Redirection menu.
3. Choose one of these options:
o On ML110 G5 servers:
i. Press the down arrow (↓) key to scroll down to the EMS Console option, and then press the
Enter key.