Configuration, Configuring network access, Configuring user accounts – HP ProLiant DL180 Server User Manual
Page 10
Configuration 10
Configuration
Configuring network access
Through your server network connection, you can access the remote management CLP, verify POS
remotely, access the server through a web browser, and access the BIOS Setup Utility remotely.
To configure network access:
1.
Connect a standard Ethernet cable from the LO100 to a network jack using one of the following
options:
o
On ProLiant ML110 G5, ML115 G5, DL120 G5, ML150 G5, and DL180 G5 servers, connect to
the NIC port on the remote management card.
o
On ProLiant DL160 G5, DL165 G5, DL185 G5, and SL165z G6 servers, connect to the onboard
LO100 NIC.
2.
Obtain the DHCP IP address, by using either of the following methods:
o
Look at the DHCP clients table.
o
Press the F10 key during POST, and then obtain the IP address from BIOS Setup Utility under
Advanced/IPMI/LAN Setting. For more information, see "Obtaining a DHCP IP address from the
BIOS Setup Utility (on page
)".
By default, LO100 has DHCP enabled and automatically negotiates an IP address.
3.
With the DHCP IP address, use one of the following options:
o
Telnet to log in to the remote management CLP
o
A web browser to access the HTML interface
To set up a static IP address, see "Setting up a static IP address from the BIOS Setup Utility (on page
".
Configuring user accounts
LO100 supports four accounts types, with varying levels of permissions to view and control features. For
more information on user accounts, see the "User administration (on page
)" section. Two accounts are
available by default, one of type administrator and one of type operator.
The administrator account enables the user to execute the full set of CLP commands and change
management processor configuration. The default administrator account user name is admin, and the
default password is admin.
The operator account enables the user to execute common commands and functions but restricts access to
specific functions, such as adding and changing user account information and changing the configuration
of the management processor. HP recommends logging in with the operator account to perform common
functions. The default user name is Operator, and the default password is Operator.
For more information on how to log in to LO100, see the "Logging in to LO100 (on page
)" section.
- ProLiant DL180 G5 Server ProLiant ML150 G5 Server ProLiant ML110 G5 Server ProLiant DL160 G5p Server ProLiant DL120 G5 Server ProLiant ML115 G5 Server ProLiant DL165 G5 Server ProLiant DL160 G5 Server ProLiant DL165 G5p Server Lights-Out 100 Remote Management ProLiant SL165z G6 Server ProLiant DL185 G5 Server