HP ProLiant DL180 Server - Manual (Page 51)

Using LO100 51
1. Log in to the CLP as described in the "Logging in to LO100 (on page 26 )" section.
2. At the command prompt, enter cd map1/accounts.
3. Select a user by entering cd user1 or cd user#, where # is the user you want to modify and a
whole number between 2 and 16.
4. To change the user name, enter set username=. For example:
/./map1/accounts/user2/> set username=testuser2
5. To change the user password, enter set password=, and enter the new
password when prompted. For example:
/./map1/accounts/user2/> set password=testpswd2
Passwords are case-sensitive and can contain up to 16 characters.
IMPORTANT: LO100 does not support either an ampersand (&) or quotation marks (") in user
names or passwords.
6. To change the group name enter, set group=. Valid group settings are
administrator, user, oemhp, and operator. For example:
/./map1/accounts/user2/> set group=user
Network settings
You can view and modify network settings for LO100 using a web browser, CLP, or the BIOS Setup
Utility. If you change the IP address, the connection to the server terminates. You must reconnect to the
server using the new IP address.