Stalled – HP XP Command View Advanced Edition Software User Manual

Page 56

TIP:
•

For details on the

YKINSCHK

command, see the

HP XP7 for Business Continuity Manager Software

Reference Guide.

•

For details on how to delete the user SVC in Business Continuity Manager, see the

HP XP7 for

Business Continuity Manager Software Installation Guide.

•

This procedure lets you install Smart Manager for Mainframe for the first time. If you need to up-
grade Smart Manager for Mainframe, refer to the instructions for preparing for the upgrade.

Related topics

• Registering a user SVC

, page 38

• Prerequisite user SVC versions for Smart Manager for Mainframe

, page 57

• Preparation for upgrading Smart Manager for Mainframe

, page 276

Notes on setting environment variables or system symbols if Business Continuity
Manager is installed

Smart Manager for Mainframe and Business Continuity Manager use the same environment variables
and system symbols. Do not change the currently enabled operating environment setting values (that
is, environment variables or values set to system symbols), in the system where Business Continuity
Manager is running. In particular, if you change the prefix of a license information dataset, you must
register the Business Continuity Manager license again because the license information dataset is
shared by Smart Manager for Mainframe and Business Continuity Manager. Change the operating
environment setting values very carefully if you need to change them.

TIP:

To check the currently enabled operating environment setting values, do the following:

•

If Smart Manager for Mainframe has already been installed (when you upgrade it)
Check the operating environment setting values that were obtained when preparing for the upgrade.

•

If Smart Manager for Mainframe has not been installed (when you install it for the first time)
Use the

YKDSPENV

command to do the check. For details on the

YKDSPENV

command, see the

HP XP7 for Business Continuity Manager Software Reference Guide.