HP XP Command View Advanced Edition Software - Manual (Page 149)

Prerequisites
• If the SCAN parameter is not specified, volumes to be defined as a tiering policy group must be
defined in the disk configuration definition file in advance by using the KTSCAN and KTSTORE
commands.
• If the record type of the tiering policy information CSV file is STORGRP or VOLSER , the volumes
must be placed online.
Format
KTIMPORT
1
MSG(stem-name-1)
1
PREFIX(prefix)
1
POLICY(policy-ID)
[
1
SCAN]
Parameters
MSG(stem-name-1) ~
Specify the prefix (any value) of the message structure that stores messages generated by this
command. This value must end with a period.
PREFIX(prefix) ~
Specify the prefix of the disk configuration definition file, tiering policy group definition file, and
tiering policy information CSV file.
POLICY(policy-ID) ~
Specify the policy-ID that identifies the tiering policy information CSV file to be read. The tiering
policy information CSV file whose name is
PREFIX-parameter-value.POLICY.policy-
ID will be read.
SCAN
The volumes or the volumes belonging to the SMS storage group, which are specified in the tiering
policy information CSV file, will be scanned in the same way as for the
KTSCAN command. Then
the detected volume information will be output to the disk configuration definition file.
TIP:
When you execute the KTIMPORT command, the following number of data sets are allocated at the
same time:
•
If you specify the SCAN parameter: The number of disk configuration definition files to be updated
#
+ 2
#: The number of disk configuration definition files to be updated is the number of storage systems
to be scanned.
• If you do not specify the SCAN parameter: 2
Therefore, ensure that the number of datasets allocated at the same time does not exceed the value
of the
DYNAMNBR parameter of the TSO/E logon procedure or JCL.
User Guide 149