HP XP Command View Advanced Edition Software - Manual (Page 28)

If you are not using SMP/E for the installation, you do not need to create a backup in the distri-
bution library.
Related topics
• Installing Smart Manager for Mainframe , page 28
• Settings required for using CLI commands (registration for authentication) , page 33
• Setting RACF security for CLI commands , page 36
• Settings for using environment configuration commands , page 37
• Registering a user SVC , page 38
• Setting the operating environment for Smart Manager for Mainframe (setting environment variables
or system symbols) , page 40
• Settings required to use Smart Manager for Mainframe on the ISPF panel , page 45
• Registering licenses , page 47
• Verifying the setup information , page 52
• Calculating required memory , page 53
• Settings required for collecting event logs , page 53
• Backing up Smart Manager for Mainframe to the distribution library , page 54
• Notes on setting up Smart Manager for Mainframe when Business Continuity Manager is already
installed , page 55
Installing Smart Manager for Mainframe
This section provides an overview and the procedure for installing Smart Manager for Mainframe.
Workflow for during installation
After transferring the load module for Smart Manager for Mainframe to a host machine, you can
install Smart Manager for Mainframe using SMP/E. Alternatively, you can install it directly in the
target library without using SMP/E.
The following figure illustrates the workflow when installing Smart Manager for Mainframe.
Figure 13 Workflow for during installation of Smart Manager for Mainframe
Related topics
• Transferring the load module to a host machine , page 29
• Performing an installation using SMP/E , page 31
• Installing directly from the provided datasets in the target library , page 32
Installation and setup 28