HP XP Command View Advanced Edition Software User Manual

Page 34

Registering the load library for LINKLIB and the KTQRYSMS command for
authentication

To register the load library for LINKLIB and the

KTQRYSMS

command for authentication to enable the

use of CLI commands:

Procedure

Concatenate the load library for LINKLIB

HPQKLNKT

LNKLST

You can concatenate by using either of the following methods:

• Static method: Specify the load library for LINKLIB

HPQKLNKT

in the PROG

parmlib member

as a dataset concatenated to the LNKLST.
To enable concatenation, you must perform an IPL again.

• Dynamic method: Use the

SETPROG LNKLST

command to concatenate the load library for

LINKLIB

HPQKLNKT

to the

LNKLST

If you cannot perform an IPL because the system is running, use this method to concatenate
the load library. However, because performing an IPL will invalidate concatenation, modify
parmlib as defined in the static method, above so the change will continue across an IPL.

HPQKLNKT

for APF authorization.

You can register by using either of the following methods:

• Static method: Add the load library for LINKLIB

HPQKLNKT

to the

PROGxx

parmlib member

as a dataset to be authorized as APF.
To enable registration, you must perform an IPL again.

• Dynamic method: Use the

SETPROG APF,ADD

command to register the load library as APF

authentication.
If you cannot perform an IPL because the system is running, use this method to perform regis-
tration. However, because performing an IPL will invalidate registration, modify parmlib as
described above in the static method so the change will be available across an IPL.

TIP:

LNKLST

has APF authorization by default, so you do not have to perform step 2, if the load

library for LINKLIB

HPQKLNKT

was concatenated with

LNKLST

in step 1. Note that there

are exceptions to this rule. For details about APF authorization related to

LNKLST

, see the

manual

MVS Initialization and Tuning Reference.

KTQRYSMS

command as a TSO/E authorized command.

Add the command name

KTQRYSMS

to the

AUTHCMD

section in the

IKJTSOxx

parmlib member.

To enable registration, you must perform an IPL again. If you use the

PARMLIB CHECK (nn)

command and the

PARMLIB UPDATE (nn)

command, registration can be enabled without

performing an IPL again. For details about the

PARMLIB

command, see the TSO/E System

Programming Command Reference.

The

KTQRYSMS

command is a CLI command that is used internally by Smart Manager for

Mainframe to acquire SMS storage group information.

For details about the

SETPROG

command, see the manual MVS System Commands.

Installation and setup

This manual is related to the following products:

XP7 Command View Advanced Edition Suite Licenses XP P9000 Command View Advanced Edition Software