HP XP Command View Advanced Edition Software - Manual (Page 168)

Note
A maximum of ten lines can be output in a multi-line message text.
Return codes
The following table lists and describes the codes returned when the KTWTOMSG command terminates.
Table 26 Return codes generated by the KTWTOMSG command
Meaning Return code
The command ended normally. 0
The type is not specified. 1004
The specified type is invalid. 1008
No text is specified. 1012
The specified text is invalid. 1016
A system error occurred. 2000
See the return codes of the WTO macro. For details, see the MVS Programming:
Assembler Services Guide.
Other than the above
TSO/E command details
This section describes details about the TSO/E type CLI commands. The commands are explained in
alphabetic order.
KTCONMSG
Function
Monitors the messages output to the console.
Command type
TSO/E command
Format
KTCONMSG
1
{OP(OPEN)[
1
MSGID(message-ID)] [
1
TIMEOUT(timeout-value)]
|OP(GET)
1
HANDLE(X'handle-value')
|OP(CLOSE)
1
HANDLE(X'handle-value')
}
Parameters
OP({OPEN|GET|CLOSE})
CLI commands 168