HP XP Command View Advanced Edition Software - Manual (Page 38)

Postrequisites
• Registering a user SVC
Related topics
• Settings required for using CLI commands (registration for authentication) , page 33
• Registering a user SVC , page 38
Registering a user SVC
You can dynamically register a user SVC by using the KTALCSVC environment configuration command,
or statically register a user SVC by using the IEASVCxx parmlib member.
If you use the IEASVCxx parmlib member to register a user SVC, you must perform an IPL again. If
you cannot perform an IPL again because the system is running, use the KTALCSVC command to
perform registration.
Registering a user SVC using the
KTALCSVC
command
Use the KTALCSVC environment configuration command to dynamically register a user SVC.
Prerequisites
• Settings for using environment configuration commands
Procedure
1. Choose an unused SVC number between 200 and 255 to assign to the user SVC.
2. Execute the following KTALCSVC command.
START KTALCSVC, PARM='SVC-number'
TIP:
The user SVC registered with the KTALCSVC command is invalidated if an IPL is performed again.
Perform either of the following in case you need to perform an IPL again the next time:
• Add the KTALCSVC command to the COMMNDxx parmlib member, so that the user SVC is auto-
matically registered when an IPL is performed again.
• Define the user SVC in the IEASVCxx parmlib member, and use the statically-registered user
SVC from the next time an IPL is performed again.
Specification examples
START KTALCSVC
By omitting the PARM parameter when executing this command, an unused SVC number between
200 and 255 is assigned.
Installation and setup 38