Removing the library linkage – HP XP Command View Advanced Edition Software User Manual
Page 278
2.
If this version is older than the prerequisite user SVC version of Smart Manager for Mainframe
after upgrading, disable (comment out) the
SYMDEF
statement that contains the
&YKSVCNO
system
symbolic name in the
IEASYMxx
parmlib member, as shown below:
/* SYMDEF(&YKSVCNO='SVC-number') */
3.
Disable (comment out) the
SVCPARM
statement that specifies the
JYUASVC
module of the
IEASVCxx
parmlib member, as shown below:
/* SVCPARM SVC-number,REPLACE,TYPE(3),EPNAME(JYUASVC),APF(NO),NPRMPT(NO),AR(NO) */
To apply the deletion of the user SVC, perform re-IPL by specifying the
CLPA
parameter. Perform re-IPL
at the end of the preparation for upgrading.
CAUTION:
A user SVC is shared by Smart Manager for Mainframe and Business Continuity Manager. Therefore,
in a system where Business Continuity Manager is installed, make sure that Business Continuity
Manager is not running before deleting the user SVC.
Related topics
• Prerequisite user SVC versions for Smart Manager for Mainframe
• KTINSCHK
Removing the library linkage
Remove all the links to libraries that were established during setup.
Procedure
1.
Remove the linkage of the
HPQYPRCT
cataloged procedure library.
• If the cataloged procedure library has been statically linked to the
IEFPDSI
DD name in the
MSTJCLxx
parmlib member, remove the linkage.
• If the
KTALCSVC
,
KTSETENV
, and
KTDSPENV
members have been copied from the cataloged
procedure library to the user's PROCLIB, delete those members.
2.
Remove the linkage of the
HPQYLNKT
load library for LINKLIB.
• If the load library for LINKLIB has been statically linked by adding it to the
PROGxx
parmlib
member, delete the load library from the member.
• If the load library for LINKLIB has been dynamically linked to
LNKLST
by using the
SETPROG
LNKLST
command, use the
SETPROG LNKLST
command to remove the linkage.
Upgrading Smart Manager for Mainframe
278