Connecting the projector, User’s manual projectin g an ima g e – Canon XEED SX6000 User Manual
Page 49
49
Connecting the Projector
User’s Manual
Projectin
g
an Ima
g
e
Connecting with a BNC cable (Input signal type: [Analog PC] (WUX5000 / WUX4000),
[Analog PC-1] (WX6000 / SX6000)
• A signal with a dot clock higher than 162 MHz cannot be projected.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
will reduce the audio volume.
• The AUDIO IN terminal can be changed in the Audio in terminal select screen (
(WX6000 / SX6000)
Computer
Monitor output
terminal
(mini D-sub 15-pin)
AUDIO output terminal
(AUDIO OUT)
BNC cable (not included)
When inputting corresponding audio
Audio cable (not included)
To ANALOG PC /
COMPONENT IN terminal
To AUDIO IN terminal
Projector
Mini D-sub 15-pin -
BNC terminal con-
verter cable (not
included)
Mini D-sub 15-pin -
BNC terminal con-
verter cable (not
included)
Computer
Monitor output
terminal
(mini D-sub 15-pin)
AUDIO output terminal
(AUDIO OUT)
BNC cable (not included)
When inputting corresponding audio
Audio cable (not included)
To ANALOG PC-1 /
COMPONENT IN terminal
To AUDIO IN terminal
Projector
Mini D-sub 15-pin -
BNC terminal con-
verter cable (not
included)
Mini D-sub 15-pin -
BNC terminal con-
verter cable (not
included)