Canon XEED SX6000 - Manual (Page 41)

41
Part Names
Before Use
(1)LAN port ( P166 )
Connects the LAN cable.
Used to connect the projector to a network.
(2)ANALOG PC-1 / COMPONENT IN terminal
( /COMPONENT IN) ( P47 , P53 )
Receives the analog PC signal (Analog PC-1).
A component cable can be used to receive the component image signal (Component).
(3)ANALOG PC- 2 / DVI-I IN terminal ( DVI-I IN) ( P50 )
Connects the external monitor output from a computer.
Receives the digital PC signal (Digital PC) or analog PC signal (Analog PC-2).
(4)HDMI IN terminal (HDMI IN) ( P51 )
Receives the digital content image signal (HDMI).
Carries both video and audio signals across a single cable.
(5)Service port (CONTROL)
This terminal is used by servicing technicians. It is not used during ordinary use.
(6)Terminal for wired remote control (REMOTE) ( P30 )
This terminal is used to connect the remote control using a cable.
(7)AUDIO IN terminal (AUDIO IN) ( P47 , P50 , P53 )
Receives the audio signal input for 2 kinds of image input except HDMI IN.
The internal speaker outputs the audio for the selected image signal.
(8)AUDIO OUT terminal ( AUDIO OUT) ( P51 , P55 )
Outputs the audio to external AV equipment. This outputs the audio signal that corre-
sponds to the projected image signal.
(1) (2) (3) (4) (5) (6) (7) (8)