Canon XEED SX6000 - Manual (Page 178)

Configuring the Network From the Computer
178
The following information is displayed.
*1 WUX5000 / WX6000 / SX6000
*2 WUX4000
4
To configure, click [Settings].
The settings window appears.
Projector name The name of the projector on the network
Location The location of projector installation
MAC address The MAC address of the projector
IP address The IP address of the projector
Power Status The power status of the projector
Lamp Time *1 Lamp operating time
Lamp Time Normal Mode *2 Lamp operating time in [Normal] lamp mode
Lamp Time Quiet Mode *2 Lamp operating time in [Quiet] lamp mode
Lamp Time Converted *2 Lamp operating time (converted value)
Filter Time Air filter operating time
Alert Error message (if an error has occurred)
Temperature abnormality
Faulty lamp
Faulty lamp cover
Faulty cooling fan
Faulty power supply
Faulty lens connector: Lens connector error
Faulty air filter unit: Air filter error
Unknown error
To operate the projector from the computer, click [Projector control] ( P188 ).