Canon XEED SX6000 - Manual (Page 155)

155
Installing / Removing the Lens Unit
Installation Manual
Installation
■Removing the Lens Unit
1
Perform steps 1 to 5 on pages 151 – 153 and remove the sleeve.
2
Disconnect the lens cable from the lens connector.
3
Fix the lens cable as shown in the illustration and loosen the 4 screws to remove the
lens unit.
The 4 lens unit screws are attached to the lens unit and cannot be removed.
When pulling out (disconnecting) the lens cable, press the buttons on both sides of the lens
cable connector while pulling out the cable.