Brother MFC-J6720DW - Manual (Page 91)

Routine maintenance
85
A
Packing and shipping
the machine
A
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
correctly, any damage that may occur in
transit may not be covered by your warranty.
The machine should be adequately insured
with the carrier.
IMPORTANT
It is important to allow the machine to
“park” the print head after a print job.
Listen carefully to the machine before
unplugging it to make sure that all
mechanical noises have stopped and the
print head is in the right corner as shown
in the illustration. Not allowing the
machine to finish this parking process may
lead to print problems and possible
damage to the print head.
a
Unplug the machine from the AC power
outlet.
b
Using both hands, use the finger holds
on each side of the machine to lift the
scanner cover into the open position.
Then unplug the machine from the
telephone wall jack and take the
telephone line cord out of the machine.
c
Unplug the interface cable from the
machine, if it is connected.
d
Remove the orange protective part from
its storage place inside the right corner
of the machine.
e
Gently close the scanner cover using
the finger holds on each side.
CAUTION
Be careful not to pinch your fingers when
you close the scanner cover.
Always use the finger holds provided on
each side of the scanner cover when
opening and closing it.