NORD Drivesystems BU0270 - Manual (Page 23)

3 Displays and diagnosis
BU 0270 GB Subject to technical amendments 23
RJ12
LEDs
Potis
RJ12
LEDs
Potentiometers
3 Displays and diagnosis
Various diagnosis possibilities are available, depending on the device. Operating conditions or errors are
visualised by means of LEDs. PC-based communication or the connection of a parameterisation unit is
possible via an RS232 interface (RJ12 diagnostic socket).
3.1 LED displays
Both the SK 200E frequency inverter and the EtherCAT modules provide LED status and diagnostic displays to
indicate the various statuses.
A differentiation into 2 categories is made
• Module or module-specific displays (S and E or DS and DE)
• EtherCAT-specific displays
(- physical status: L/A in and L/A out
- Process status: RUN and ERR)
3.1.1 Device-specific display versions
3.1.1.1 SK 200E frequency inverter
LED S/E
The double LED S/E indicates the operating status of the
frequency inverter by change of colour and different flashing
frequencies. A device error is indicated by cyclic red flashing
of the LED. The frequency of the flashing signals
corresponds to the error number (Manual BU 0200).
LEDs BS and BE
The dual LEDs BS (BUS State) and BE (BUS Error)
indicate the status of the system bus communication module.
Various bus communication errors are indicated by means of
different flashing frequencies.
A detailed description of the LED displays of the frequency
inverter can be found in the main manual (BU0200).
Frequency inverter SK 200E
viewing window (transparent screw-on cover) for
diagnostic interface RJ12, status LEDs, potentiometer
EtherCAT Module SK TU4-ECT with
SK TI4-TU-BUS and SK TIE4-WMK-TU
Status LEDs and screw connection for RJ12
diagnostic interface
RJ12
BUS Status BS and BE
Status LED S/ E