NORD Drivesystems BU0270 - Manual (Page 13)

2 Assembly and installation
BU 0270 GB Subject to technical amendments 13
2.1.1 Overview of the EtherCAT modules
Bus Module Description Data
EtherCAT module *)
SK TU4-ECT(-C)
Part No. 275281117 (IP55)
Part No. 275281167 (IP66)
This option enables control of the
NORDAC SK 200E via EtherCAT.
This option is installed externally to the frequency
inverter.
According to the installation location, at least one
"BUS connection unit"* is required.
Supported profile:
CoE
Baud rate:
up to 100 MBaud
Connection:
36 pin spring terminal bar
of the “BUS connection unit”*
8x Digital inputs:
Low: 0-5V, High: 11-30V
2x Digital outputs:
0/24V
System bus
Connection unit for TU4
SK TI4-TU-BUS
Part No. 275280000 (IP55)
Part No. 275280500 (IP66)
The connection unit is always required in order to
use an external technology unit (SK TU4-...). This
implements the connection of the technology unit to
the SK 200E or the wall-mounting kit.
Connection:
36 pin spring terminal bar
36x 2.5mm
2
AWG 26-14
spring terminals
TU4 Wall-mounting kit
SK TIE4-WMK-TU
Part. No. 275274002
With the wall mounting kit, a technology unit can be
used/installed separately from the SK 200E.
*) in order to use the TU4 modules, a suitable
SK TI4-TU-BUS connection unit must always be available!