KANOMAX 3910 Portable Particle Counter User Manual User Manual

Page 61

3. Display Description and Operation Procedure

· ALARM SETTING

In ALARM SETTING you can set thresholds for
the particle alarm and option sensor alarm.

In the PARTICLE tab, configure the unit and
threshold for each particle.
Check the particle size that you want to alarm
by external contact output and audible
alarm*.
(* Note that audible alarm will be activated
only when “Alarm Sound” is checked.)

Also enter the threshold that you want to
trigger the alarm.
To enter the threshold, tap the entry field to
display a numeric keypad. Enter a value and
tap [Enter].

In the OPTION tab, you can set an alarm
threshold for TEMPERATURE, HUMIDITY,
VELOCITY and DIFFERENTIAL PRESSURE.
Tap the entry field to display a numeric keypad.
Enter a value and tap [Enter].
To activate the audible alarm check “Alarm
Sound”.

Tap [APPLY] to save the settings
(Authentication required).
The window is not closed.

Tap [OK] to save the settings and close the
window.

(Authentication required).

Tap [CANCEL] to discard the settings and close
the window. The previous configuration will be
applied.