KANOMAX 3910 Portable Particle Counter User Manual User Manual

Page 53

3. Display Description and Operation Procedure

3.6.6 In Case that Measurement is Interrupted

If you stop a measurement in STATS or STANDARD mode before all measurements complete, and
there is more than one location where a determined set of measurements is finished, the
instrument will be in a temporary state of suspension.
The instrument will remain in a temporary state of suspension until a measurement restarts or
completes. During this period you cannot change the measurement mode or MODE settings.

[STATS]
If you start a measurement when the instrument is in a temporary state of suspension, the
message below will be displayed.

Tap [YES] to resume measuring from the next
LOCATION.
If you tap [NO], you will get a message asking if you
want to save the data or not.
Tap [CANCEL] to go back to the main screen.

If you tap [NO] on the window above, a
confirmation window will be displayed
asking if you want to save the data or not.
Tap [YES] to save the data.
Tap [NO] to discard the data.

If you try to switch the mode, the message below will be displayed.

Tap [OK].
You cannot change the mode when a measurement is
in a temporary state of suspension.