KANOMAX 3910 Portable Particle Counter User Manual - Manual (Page 47)

3. Display Description and Operation Procedure 39
Select a Location and tap [DETAIL] to view
the image of the selected Location. (The
image of the Location needs to be registered
when creating a Schedule using the provided
PC application.)
Tap [START] to start a measurement.
 If “START DELAY” is NOT checked in
“MODE” setting:
Upon tapping [START], the pump will begin
running. After the pump has run for 10
seconds to stabilize, the measurement will
begin.
 If only “START DELAY” is checked in
“MODE” setting:
Upon tapping [START], the Delay Time
begins. During the last 10 seconds of that
Delay Time the pump will run to stabilize,
after which the measurement will begin.
 If “START DELAY” and “Set time” are
checked in “MODE” setting:
Upon tapping [START], “Input START TIME”
dialog box will be displayed. Enter the time
when you want to start measuring and tap
[OK]. During the last 10 seconds of the
[Time left] time the pump will run to
stabilize, after which the measurement will
begin.
Tap [CANCEL] to go back to the menu
screen.
If you fail to press [OK] after entering
“START TIME”, and the entered START TIME
arrives, the instrument will increase the
start time in 10 minute intervals until you
press [OK].
After closing the measurement results, tap
button while measuring to display a
chart.