KANOMAX 3910 Portable Particle Counter User Manual User Manual
Page 48
3. Display Description and Operation Procedure
40
When a measurement at each location is finished,
the measurement results will be displayed.
In [RAW DATA] tab, measurement data will be
displayed.
In [CALC DATA] tab, data of minimum (MIN),
maximum (MAX) and average (AVE)
measurements will be displayed.
Tap [NEXT] to display the MAP again and wait for
the next point to be selected.
Tap [REMEASURE] to perform a
re-measurement.
Tap [STOP] to stop a measurement.
Tap [PRINT] to print measurement results.
The color of a location changes from green to red
once a measurement is done.
When all measurements are finished, the final
measurement results will be displayed.
You can view the result of a certain LOCATION
POINT by selecting Location from the dropdown
list.
Tap [EVAL] to display “CLEAN ROOM
EVALUATION” screen.
Tap [REMEASURE] to perform a re-measurement
at the current location.
Tap [PRINT] to print a measurement result.
Tap [PRINT] to print a measurement result.
By selecting particle size you can change the
particle size of the data to be evaluated. However,
the status indicated by RESULT is determined
based on the particle size selected in the “MODE”
setting.
Tap [Close] to close the window.